iosxr_command - Run commands on remote devices running Cisco IOS XR

• Synopsis
  • Requirements
• Parameters
• Notes
• Examples
• Return Values
• Status
  • Support
  • Author

Synopsis

• Sends arbitrary commands to an IOS XR node and returns the results read from the device. This module includes an argument that will cause the module to wait for a specific condition before returning or timing out if the condition is not met.
• This module does not support running commands in configuration mode. Please use iosxr_config to configure iosxr devices.

Requirements

The below requirements are needed on the host that executes this module.

• ncclient >= 0.5.3 when using netconf
• lxml >= 4.1.1 when using netconf

Parameters

Notes

Examples

tasks:
  - name: run show version on remote devices
    iosxr_command:
      commands: show version

  - name: run show version and check to see if output contains iosxr
    iosxr_command:
      commands: show version
      wait_for: result[0] contains IOS-XR

  - name: run multiple commands on remote nodes
    iosxr_command:
      commands:
        - show version
        - show interfaces
        - { command: example command that prompts, prompt: expected prompt, answer: yes}

  - name: run multiple commands and evaluate the output
    iosxr_command:
      commands:
        - show version
        - show interfaces
      wait_for:
        - result[0] contains IOS-XR
        - result[1] contains Loopback0

Return Values

Common return values are documented here, the following are the fields unique to this module:

Status

This module is flagged as preview which means that it is not guaranteed to have a backwards compatible interface.

Support

For more information about Red Hat’s support of this module, please refer to this Knowledge Base article

Author

• Ricardo Carrillo Cruz (@rcarrillocruz)