na_ontap_igroup_initiator – NetApp ONTAP igroup initiator configuration

• Synopsis
• Requirements
• Parameters
• Notes
• Examples
• Status

Synopsis

• Add/Remove initiators from an igroup

Requirements

The below requirements are needed on the host that executes this module.

• A physical or virtual clustered Data ONTAP system. The modules support Data ONTAP 9.1 and onward
• Ansible 2.6
• Python2 netapp-lib (2017.10.30) or later. Install using ‘pip install netapp-lib’
• Python3 netapp-lib (2018.11.13) or later. Install using ‘pip install netapp-lib’
• To enable http on the cluster you must run the following commands ‘set -privilege advanced;’ ‘system services web modify -http-enabled true;’

Parameters

Notes

Examples

- name: Add initiators to an igroup
  na_ontap_igroup_initiator:
    names: abc.test:def.com,def.test:efg.com
    initiator_group: test_group
    vserver: ansibleVServer
    hostname: "{{ netapp_hostname }}"
    username: "{{ netapp_username }}"
    password: "{{ netapp_password }}"

- name: Remove an initiator from an igroup
  na_ontap_igroup_initiator:
    state: absent
    names: abc.test:def.com
    initiator_group: test_group
    vserver: ansibleVServer
    hostname: "{{ netapp_hostname }}"
    username: "{{ netapp_username }}"
    password: "{{ netapp_password }}"

Status

• This module is not guaranteed to have a backwards compatible interface. [preview]
• This module is maintained by the Ansible Community. [community]

Authors

• NetApp Ansible Team (@carchi8py) <ng-ansibleteam@netapp.com>