1 Introduction
Megaco/H.248 is a protocol for control of elements in a physically decomposed multimedia gateway, enabling separation of call control from media conversion. A Media Gateway Controller (MGC) controls one or more Media Gateways (MG).
This version of the stack supports version 1, 2 and 3 as defined by:
-
version 1 - RFC 3525 and H.248-IG (v10-v13)
-
version 2 - draft-ietf-megaco-h248v2-04 & H.248.1 v2 Corrigendum 1 (03/2004)
-
version 3 - Full version 3 as defined by ITU H.248.1 (09/2005) (including segments)
The semantics of the protocol has jointly been defined by two standardization bodies:
-
IETF - which calls the protocol Megaco
-
ITU - which calls the protocol H.248
1.1 Scope and Purpose
This manual describes the Megaco application, as a component of the Erlang/Open Telecom Platform development environment. It is assumed that the reader is familiar with the Erlang Development Environment, which is described in a separate User's Guide.
1.2 Prerequisites
The following prerequisites is required for understanding the material in the Megaco User's Guide:
-
the basics of the Megaco/H.248 protocol
-
the basics of the Abstract Syntax Notation One (ASN.1)
-
familiarity with the Erlang system and Erlang programming
The application requires Erlang/OTP release R10B or later.
1.3 About This Manual
In addition to this introductory chapter, the Megaco User's Guide contains the following chapters:
-
Chapter 2: "Architecture" describes the architecture and typical usage of the application.
-
Chapter 3: "Internal form and its encodings" describes the internal form of Megaco/H.248 messages and its various encodings.
-
Chapter 4: "Transport mechanisms" describes how different mechanisms can be used to transport the Megaco/H.248 messages.
-
Chapter 5: "Debugging" describes tracing and debugging.
1.4 Where to Find More Information
Refer to the following documentation for more information about Megaco/H.248 and about the Erlang/OTP development system:
-
the ASN.1 application User's Guide
-
the Megaco application Reference Manual
-
Concurrent Programming in Erlang, 2nd Edition (1996), Prentice-Hall, ISBN 0-13-508301-X.
© 2010–2021 Ericsson AB
Licensed under the Apache License, Version 2.0.